Kostal PIKO 1.5 MP, Руководство по эксплуатации

Страница: 37 / 80

1. If necessary, establish the data connection:
n
Connect the inverters and the master with data connection
cables.
n
On the last inverter, switch on the termination (slide switch).
2. Seal open RJ45 sockets with sealing caps.
3. Forcefully press the plug connector mating piece (DC cable) into the
DC connection on the inverter until it audibly locks in place.
4. Plug the AC connector onto the coupling on the inverter, until the plug
audibly locks in place.
5. Switch on the AC miniature circuit breaker. The start page for 1st
commissioning is shown on the display.
6. Perform initial commissioning and switch on the DC supply, as
described in the following.
4.7 Initial commissioning of the inverter
4.7.1 Function
Initial commissioning starts automatically when at least the AC connector
has been installed and switched on as described previously. If initial com‐
missioning is not fully completed then it starts again anew the next time
the device is switched on.
Initial commissioning is a guided procedure that sets the following informa‐
tion:
n
Display language
n
Date / Time
n
Country
n
Reactive power characteristic curve (if prescribed for the selected
country)
The following applies when setting the country:
n
The country set must always be the same as the country where the
inverter is installed. This causes the inverter to load the prescribed grid
parameters for the selected country. For a list of country settings, refer
to our website under
www.kostal-solar-electric.com/Download/PIKO_MP
.
n
The country can only be set once!
If you have mistakenly selected the wrong country, reset the country
setting in the Service menu ( Ä
Chapter 3.3.4 „Service
menu“ on page 17
).
Conditions for starting
initial commissioning
Guided initial commis‐
sioning
Setting the country
Installation
11/2017 | DOC01664604 | KOSTAL operating instructions PIKO inverter 1.5 - 4.2 MP 37