KNIGHT D-SERIES SERVO HOIST OPERATION MANUAL
SECTION 6
PARAMETER DESCRIPTIONS
104
iSTS:2 – System Number
Description: This parameter displays a second portion of the Knight Global Job Number. The system
number increments if there are multiple hoists on the same job number. This second portion always follows
the Knight Global Job Number preceded by a dash.
Example: If a ‘2’ is displayed here, then the system’s full job number would be: 186042-2
KSS Home screen location: Quick View panel \ Row 6 (Lower right-hand portion of the screen)
iSTS:3 through
iSTS:7 – Spare
E. dPRM Parameter Array
This parameter array lists the Double Integer Parameter variables of the Servo Hoist that are made available
to the Knight Servo Studio (KSS).
The parameters listed in the dPRM array are double integer values being sent from the Knight Servo Studio
to the hoist and are displayed at:
KSS Workspace tree location: Knight WO# \ Parameters \ dPRM.
dPRM:0 – Test Cycle Count Target
Variable Units: Integer
Description: This parameter controls the number of cycles that the servo will execute in Test Mode after it is
initiated unless a stop or fault occurs. Setting this parameter to zero will result in the servo not automatically
stopping during Test Mode.
KSS Workspace tree location: Knight WO# \ Motion \ Test Mode \ Row 5.
dPRM:1 through
dPRM:7 – Spare
F. dSTS Parameter Array
This parameter array lists the Double Integer Parameter variables of the Servo Hoist that are made available
to the Knight Servo Studio (KSS).
The parameters listed in the dSTS array are Double Integer values being sent from the hoist to the Knight
Servo Studio and are displayed at:
KSS Workspace tree location: Knight WO# \ Parameters \ dSTS.
dSTS:0 – Firmware Version
Variable Units: Integer
Description: This parameter displays the firmware version that the servo is currently running.
KSS Home screen location: Quick View panel \ Row 4 (Lower right-hand portion of the screen).
dSTS:1 – Job Number
Variable Units: Integer
Description: This parameter displays the Knight Global Job Number of the system. Example: 186042.
KSS Home screen location: Quick View panel \ Row 5 (Lower right-hand portion of the screen)
dSTS:2 – Spare
dSTS:3 – Test Cycle Count
Variable Units: Boolean (0=Off, 1=On)
Description: This parameter displays the current count or number of cycles the servo has performed while in
Test Mode. This count is resettable.
KSS Workspace tree location: Knight WO# \ Motion \ Test Mode \ Row 9.
dPRM:4 through
dPRM:7 – Spare