21
Technical Manual
Kingspan SHE Control Panel TRZ Plus
2A and TRZ Plus Comfort
12/24999513
Connecting Multisensor (MS) for
Measurement of Humidity (%),CO
2
-Quality
(ppm)& Temperature (C°) for the Room Air
All work to be carried out without mains supply (230V AC) or any batteries connected. Route the connecting cables into the
control panel housing at the top. Connect all connecting cables according to the wiring diagram and make sure that they are
correctly connected. Incorrected connections or figure or colour mix-ups can lead to incorrect function of the control panel or
of the external components. The notes and installation directives in the technical documentation are always to be observed.
Variant 1:
Standard connections for the power supply of the multisensor. Notes to the DIP switches are observed.
Are an external buzzer or flashing light connected to signal an SHE message to these terminals, the energy supply of the
terminals to the additional board WRMAS is apparent (see Option 2).
20 21 11 10 8
MS
6
á
á
S
P Ö
S
P Ö
+24 V DC
GND
Ensure jumper
position !
open
close
Variant 2:
Energy supply for the multisensor to the terminals of the additional board WRMAS to power a wind rain detector. A wind-/
rain sensor must not be connected together with a multisensor at these terminals. In this case, the connection variant 1 is to
be chosen.
Note:
When using terminals 20 and 21 to the power of the multisensor, the DIP switch must be set 3 + 9 of ON.
Note:
Detailed information to the multisensor, refer to the documentation.
11 10 8
MS
S
P Ö
6
á
á
+
-
TRZ WRMAS
20 21 22 23
S
P Ö
+24 V DC
GND
Ensure jumper
position !
Multisensor
open
close