Kikusui KFM2151, Руководство по эксплуатации

Страница: 38 / 112

3-4
KFM2151
Operation
3.4 Setting the Channels
The KFM2151 allows voltmeter and impedance channels to be configured (two
system configuration). The voltage measurement and the impedance signal selector
operate independently.
By factory default, the SENSING terminal numbers and logical channel numbers
match as shown in Fig.3-3. If the SENSING terminal is connected as shown in
Fig.2-8, the KFM2151 scans in order from cell 1.
Page 3-9
You can also arbitrarily assign the SENSING terminal numbers to channels and
perform scanning.
Fig.3-3 T w o system config u ration (factory defa u lt example)
Page 3-7
When setting an impedance channel, select the desired channel and set the scanned
source (ON/OFF).
Page 3- 8
When setting a voltage channel, select the desired channel and set the scanned
source (ON/OFF), voltage protection, and range.
Channel number
Page 3-12
The highest digit of the channel number of the master unit shows zero. The highest
digit for slave units shows a number between 1 and 4 (unit number). The unit
numbers are set in the CONFIG settings.
V al u e: 1 to 32
A buzzer sounds if the selectable range is exceeded.
See
Voltmeter
KFM2151
Impedance meter
To the KFM2150
Measures the signal of a
channel selected among
32 channels and displays
t h e r e s u l t o n t h e
KFM2151.
S e n d t h e s i g n a l o f a
channel selected among
3 2 c h a n n e l s t o t h e
KFM2150.
SENSING terminal
Voltage measurement
Impedance signal selector
CH1
CH2
CH3
CH1
CH2
CH3
See
See
See