Kikusui KFM2151, Руководство по эксплуатации

Страница: 36 / 112

3-2
KFM2151
Operation
3.1 Powering Up
For the power-up procedure of the impedance measurement system that includes the
PLZ-4W Series, see the operation manual of the KFM2150 FC Impedance Meter.
Turning on the POWER switch
1.
Check that the PO W ER s w itch on the rear panel is t u rned off ( ).
Page 2-5, Page 2-9
2.
Check all w iring connections.
3.
P u sh the ( ) side of the PO W ER s w itch to t u rn the KFM2151 on.
If you are using multiple KFM2151s, turn the POWER switch of the slave units first
and then the POWER switch of the master unit.
The KFM2151 starts up in the condition in which the power was turned off the
previous time.
Checking the firmware version
When the power is turned on, all LEDs illuminate for approximately 1 second.
The VOLT/TERM display section shows the firmware version for approximately
2 seconds.
Fig.3-1 Firm w are v ersion display (example for 1.00)
3.2 Monitor
The KFM2151 has two modes: monitor and setup.
When in monitor mode, the KFM2151 scans the voltage at all times. Voltage
scanning stops when setting various conditions.
■
Monitor (MON)
Pressing the MON key causes the KFM2151 to enter monitor mode.
Set the KFM2151 to monitor mode to check the active channels and start/stop the
impedance scanning. Pressing the MON key when the KFM2151 is in monitor
mode causes the buzzer to sound.
■
Setup (CH, OVP, UVP, RANGE, and TERM)
Sets the logical channels, SENSING terminals, range, and protection function.
See