Kikusui KFM2151, Руководство по эксплуатации

Страница: 67 / 112

KFM2151
4-13
Remote Control
*SRE
Sets the service request enable register bits.
The service request enable register is used to select the summary messages in the
status byte register that will be able to perform service requests.
To clear the service request enable register, send *SRE 0. If the register is cleared,
service requests cannot be generated by status information.
Command
*SRE <NR1>
*SRE?
Parameter
V al u e: 0 to 255
An SCPI error (-222, "Data out of range") occurs if outside the
range.
(Example) Sending *SRE 8 sets bit 3 of the service request enable register. Each time the
summary bit (bit 3) of the QUEStionable status register in the status byte is
set, a service request message is generated.
Response
Returns the value of the service request enable register in the <NR1> form in
response to *SRE?.
*STB
Page 4-26
Queries the contents of the status byte register and the MSS (master summary
status) message.
The response is the same as that of serial polling only with the exception that the
MSS message appears in place of the RQS message in bit 6.
Command
*STB?
Response
Returns the value of the status byte register and the MSS message (bit 6) in <NR1>
form in response to *STB?.
*TRG
Because there is no trigger function built into the KFM2151, *TRG results in a
command error.
Command
*TRG
See