Kikusui KFM2151, Руководство по эксплуатации

Страница: 64 / 112

4-10
KFM2151
Remote Control
4.4.3 Default Conditions
Page 4-12
Table 4-3 shows the default conditions when *RST, CONF:VOLT,
CONF:VOLT:ALL, or MEAS? is sent and when the KFM2151 is shipped from the
factory. When the power is turned on, the parameters in Table 4-3 are set to the
settings that existed when the POWER switch was turned off.
Ta b le 4-3 Defa u lt conditions
See
Setting
V al u e
Unit N ote
*RST
Factory
Defa u lt
CO N F
*1
MEAS?
*1. W hen CO N F: V OLT or CO N F: V OLT:ALL is sent.
CHA N : V OLT:TERM
*2
*2. Chan: 1, term±: 01, v oltage scanning: on
N o change –
Sets the channels on w hich to
perform v oltage scanning.
CHA N : V OLT: N SEL
1 N o change –
Specify the channel on w hich
to perform v oltage scanning.
CHA N :ROUT:TERM
*3
*3. Chan: 1, term±: 01, impedance scanning: on
N o change –
Sets the channels on w hich to
perform impedance scanning.
CHA N :ROUT: N SEL
1 N o change –
Specify the channel on w hich
to perform impedance
scanning.
V OLT:RA N G
200
*4
*4. Range specified b y CO N F: V OLT, CO N F: V OLT:ALL, and MEAS?
–
V OLT:RA N G:AUTO O N
*4
–
V OLT:PROT 200 200 V
V OLT:PROT:LO W -2.00 -2.00 V