Kikusui KFM2151, Руководство по эксплуатации

Страница: 46 / 112

3-12
KFM2151
Operation
3.7 CONFIG Settings
This section explains how to set the CONFIG parameters for using the KFM2150.
The CONFIG parameter number and condition are displayed as shown in Fig.3-11.
Fig.3-11 Example of a CO N FIG setting display
Parameters and conditions
Ta b le 3-4 Parameter and settings
1.
Check that the KFM2151 is in monitor mode.
If the CHANNEL display or VOLT/TERM display is blinking, press the MON key.
2.
Press SHIFT+CO N FIG.
The CHANNEL display blinks, and parameter number 000 is shown.
3.
Press the or key to select the parameter n u m b er.
4.
Press the SET key.
The VOLT/TERM display blinks, and the conditions are shown.
5.
Press the or key to select the condition.
6.
Press the SET key to confirm.
The CHANNEL display blinks. To set other conditions, repeat steps step 3 and 6 .
7.
T u rn the PO W ER s w itch off and then t u rn it b ack on.
The specified conditions are activated.
Parameter
Nu m b er
Parameter Condition
000
RS232C
Ba u d rate 19 200 b ps/9 600 b ps/4 8 00 b ps/2 400 b ps
001 Data length 7 b its/ 8 b its
002 Stop b it 1 b it/2 b its
003 Ackno w ledge message O N /OFF
010 Unit n u m b er
00: Master u nit
01/02/03/04: Sla v e u nit
IMP IMP
VOLT VOLT
V V CH CH
OVP OVP
UVP UVP
RANGE RANGE
TERM TERM
VOLT TERM CHANNEL
Parameter number
Off
Off
Condition