Kikusui KFM2151, Руководство по эксплуатации

Страница: 97 / 112

KFM2151
4-43
Remote Control
4.9 Tutorial
This section describes the procedures to make voltage measurements through
remote control on the KFM2151.
4.9.1 Simple measurement procedure (MEASure)
For simple measurement procedures, use the MEASure:VOTLage? query. When
you use the MEASure:VOLTage? query, all measurement conditions except the
range setting are set to default, and the measured data can be retrieved easily.
Example:
CHAN:VOLT:NSEL 1 ' Select logical channel 1.
MEAS:VOLT? ' Start voltage scanning on all
activated channels, and query the
measured data of the selected
channel.
Response example: 1.72000E00
Example 2:
MEAS:ARR:VOLT? ' Start voltage scanning on all
activated channels, and query the
measured data of all activated
channels.
Response example: 1.72000E00,1.69000E00,2.92000E00
Because the MEASure:VOLT? query inherently calls the CONFigure command, the
voltage measurement range is set as shown in Table 4-20.
Ta b le 4-20 V oltage meas u rement range set b y MEAS
The MEAS:VOLT? and CONF commands have parameters (can be omitted).
MEASure:VOLT? [<numeric>]
CONFigure:VOLT [<numeric>]
Specify the estimated range of the measured data in <numeric>.
If <numeric> is set to DEFault or is omitted, AUTO range is used.
Setting command V al u e
V oltage meas u rement range V OLT:RA N G Specified v al u e (AUTO w hen omitted)
V oltage protection (O V P) V OLT:PROT 200
V oltage protection (U V P) V OLT:PROT:LO W -2