Kikusui KFM2151, Руководство по эксплуатации

Страница: 27 / 112

KFM2151
2-5
Installation and Preparation
2.4 Connecting the KFM2151 to the FC
Impedance Meter
Use AWG24 wires. The recommended amount of covering to be stripped is
approximately 10 mm. Using the strip gauge shown in Fig.2-2 will ensure proper work.
When using a single KFM2151
Fig.2-2 Connection of one KFM2151 to the KFM2150
Use channel 2 of the KFM2150 VOLTAGE SENSING terminal. Select Setup >
Input Select > Voltage Sensing from the KFM2150 menu and select channel 2. For
details on KFM2150 menu, see the operation manual of the KFM2150.
1.
Check that the PO W ER s w itch is t u rned off on the KFM2151 and
KFM2150.
2.
Using a scre w dri v er, insert the w ire into the scre w less terminal
connector ( b ipolar) pro v ided as sho w n in Fig.2-2.
3.
After yo u insert the t w o w ires, t w ist the w ires together.
4.
Insert the scre w less terminal connector ( b ipolar) to the OUT terminal of
the KFM2151.
L H
Wire insertion hole
Screwless terminal
connector (bipolar)
Wire insertion hole
Twist
Insert the wire by pressing with
the tip of a screwdriver.
Return it to the original position
after inserting the wire to fix
the wire in place
Insert the wire by pressing
with the tip of a screwdriver.
Insert into the OUT
terminal of the KFM2151
KFM2150 connection cable
KFM2151
KFM2150
Strip gauge
10 mm