Kantronics KAM 98, Руководство пользователя

Страница: 289 / 384

LTP n dest [via call1[,call2,...]] (n =1-4)
default GPS (for n = 1-4)
This command sets the destination callsign and the digipeaters used to transmit
the LT strings. n specifies which string (1-4). The destination callsign defaults to
GPS; however, you may want to change it to APRS, LOCATE, POSIT, or some
other destination. Up to 8 digipeater callsigns may be specified.
See also: lt
LTRACK n [LT1] [LT2] [LT3] [LT4] [SYSOP] [TIME]
default 0
This command allocates memory for a special tracking buffer used to store LT
messages. n defines the amount of memory (Kbytes) set aside for the LT mes-
sages (limited by available RAM). Specifying the LT1 through LT4 parameters
determines which messages will be stored in the tracking buffer. If SYSOP is
specified, only a user with SYSOP privileges may access the tracking buffer, and
if TIME is specified, a time stamp will be included, in front of the LT message.
Specified LTs are put in the LTRACK buffer based on the BLT settings.
The LTRACK buffer is accessed by connecting to the mailbox (MYPBBS) and
using the mailbox’s List Tracking buffer Command (LTR). To see the syntax of
this command, type HELP at the BBS prompt.
To change LTRACK, you need to enter the entire command name, LTRACK, not just
the short form (LTR).
See also: ltp, blt, GPS operation section
MALL {ON | OFF}
default ON
KAM’98 Commands Command Reference
KAM’98 v 8.3 271 User’s Guide