Kantronics KAM 98, Руководство пользователя

Страница: 259 / 384

name, and the new list of from 1 to 10 callsigns will replace whatever list was
there before. The CONLIST command can be used to add a single
callsign (+callsign), so long as there is room for the new callsign on the list
(if there is not, the TNC responds with “EH?” and returns you to the command
prompt). Similarly, you can remove a single callsign (-callsign) from the list.
And to remove all items from the current list, enter CONLIST NONE.
A callsign entered without a SSID will match any SSID of that callsign. To match
a specific SSID only, enter the callsign with that SSID: for example, callsign-n,
where n = 0-15.
CONMODE {CONVERS | TRANS}
default CONVERS
This command controls the mode the TNC will be placed in AUTOMATICALLY
after a connect if NOMODE is OFF. The connect may result either from a con-
nect request received or a connect request originated by a CONNECT command.
If the TNC is already in Convers or Transparent Mode when the connection is
completed, the mode will not be changed. If you have typed part of a command
line when the connection is completed, the mode change will not take place until
you complete the command or cancel the line input.
See also: canline, connect, convers, nomode, trans
#
CONNECT call1 [VIA call2,call3,...,call9]
immediate
call1 = callsign of station to be connected to.
call2,...,call9 = optional stations to be digipeated through. A maximum of 8
digipeater addresses (callsigns or aliases) can be specified. This is referred to as a
path.
Each callsign may also have an optional Secondary Station Identifier (SSID)
specified as -n, where n = 1 - 15. The digipeat callsigns are specified in the order
KAM’98 Commands Command Reference
KAM’98 v 8.3 241 User’s Guide