Kantronics KAM 98, Руководство пользователя

Страница: 288 / 384

is room for the new callsign on the list (if there is not, the TNC responds with
“EH?” and returns you to the command prompt). Similarly, you can remove a
single callsign (-callsign) from the list. And to remove all items from the current
list, enter LLIST NONE.
A callsign entered without a SSID will match any SSID of that callsign. To match
a specific SSID only, enter the callsign with that SSID: for example, callsign-n,
where n = 0-15.
LT {n [text] | RESTART } (n = 1-4) (text up to
128 chars)
immediate
This command is used with GPS activity. Entering n “text” fills the specified LO-
CATION Text (LT) buffer with “text”. n specifies which buffer to use (1-4). If
GPSHEAD is set for this buffer, and if the INTFACE command is set to GPS, the
buffer contents will be updated automatically by the GPS data.
To clear one of the 4 LT strings, enter “LT n%”, where “n” is the number of the
LT string you want to clear.
Entering RESTART causes the LT buffers to be output in an unformatted manner
via the RS-232 port, and the BLT timers are restarted. “Unformatted” means that
only non-empty LT strings are output and that there is no proceeding number in-
dicating which strings are output.
Note: When switching from 300 baud packet operation on HF to 1200 baud packet
operation on VHF/UHF, remember to change the following (HF defaulted) parame-
ters: Mark, Space, SWP, slottime, Persist, Maxframe, Paclen, Hbaud. See the
packet section in the modes of operation chapter for further detail (page 144).
See also: blt, gpshead, ltp, ltrack
Command Reference KAM’98 Commands
User’s Guide 270 KAM’98 v 8.3