3-13
No.
Item
Measuring
instruments &
Input signals
Mode
Measuring point (
*
)
Adjustment parts (
-
)
Adjustment level (
+
)
Adjustment procedure
2
1
INPUT LEVEL
setting
Camera mode
*
LINE OUT
-
AUDIO LEVEL VR
+
-8dBs
(1) Input the test signal (1KHz /+4dBs) to the LINE
input, adjust the adjustment point to the speci-
fied level.
Audio tester
1KHz/+4dBs
3.4.2
AUDIO adjustment
Audio adjustments are required to input the test signal from LINE input.
All switches and VR’s should be set the position as below table.
AUDIO INPUT (INPUT1/INPUT2) : LINE
AUDIO MODE (MENU)
: 48k
CH2 INPUT
: INPUT 2
AUDIO SELECT
: MANUAL
AUDIO REF.LEVEL (MENU)
: –20dB
MONITOR SELECT
: BOTH
OUTPUT CHARACTOR (MENU)
: ON
WIND CUT (MENU)
: OFF
TEST TONE (MENU)
: OFF
Audio level
meter adjust-
ment
Camera mode
LCD should be
Spread indica-
tion
ADJUST MENU
No.60 : AUDIO
LEVEL (CH-1)
No.61 : AUDIO
LEVEL (CH-2)
*
LCD MONITOR
(Audio level meter)
-
Auto adjustment
+
-20dBs
(1) This adjustment item should be do after com-
plete the INPUT LEVEL setting.
(2) Press the USER 1/2 button to select ADJUST
MENU No.60 “AUDIO LEVEL (CH1)”.
(3) Press the JOG dial to display (blink) the * mark
on the adjustment screen.
(4) Press the JOG dial again to clear the * mark
display.
(5) Press the USER1 button to select ADJUST
MENU No.61 “AUDIO LEVEL (CH2).
(6) Perform the adjustment using steps same as
(3) and (4) above.
(7) Turn off the power once and turn it on again.
(8) Press the DISPLAY button to select enlarged
display for the LCD level meter.
(9) Check that the LCD level meter is lit to the
level of –20dB.
1KHz/+4dBs
