2-11
No.
Item
Reference picture/drawing
Procedure
1
Å
Cassette housing assembly
2
1
Drum assembly,
2
Motor bracket (Gear cover)
assembly
2.7
REPLACEMENT OF MAJOR PARTS
⋅
Make sure that the mechanism is in the ASSEMBLY mode before proceeding to disassembly or assembly. (See section 2.1,
“Assembly Mode”.)
⋅
Screws must always be tightened using a torque screwdriver and at the specified torque.
<Removal>
1
Drum assembly
1) Remove the 3 screws (S2) and take out the as-
sembly.
2
Motor bracket (Gear cover) assembly
1) Remove the 2 screws and take out the motor
bracket assembly.
2) After removing the lock of the motor bracket, the
motor can be removed by lifting the motor upward.
<Attaching>
1) Reverse the removal procedure
<Removal>
1
Cassette housing assembly
See the 1.3.2 Cassette housing on the page 1-4.
2
Outer unit assembly
1) Align the boss
Å
that pulls out the cassette hous-
ing to the round hole
ı
of Outer unit assembly,
and then remove it.
<Attaching>
1) Reverse the removal procedure.
Fig. 2-7-1
Fig. 2-7-2
NOTE
⋅
When mounting the motor, make sure that
the claw of the motor bracket is properly
locked.
If the claw is not properly locked, change the
direction for mounting the motor.
B
A
2
(S5)
1
(S5)
(L1)
(L1)
5
(S2)
1
2
3
(S2)
4
(S2)
7
(S2)
8
(S2)
