2-2
POLE BASE
CTL PLATE
MAIN BRAKE(S)
ON
ON
OFF
OFF-OFF
OFF-ON
ON-OFF
ON-ON
OFF
EJECT
C-IN
ASSEMBLY
H. LOAD
L-END
REV
FWD
STOP
2.2
BASICS OF MECHANISM DISASSAMBLY/ASSEMBLY
2.2.1
Assembly mode
The disassembly and assembly of the mechanism can be done
in the ASSEMBLY mode (see Table 2-2-1).
The ASSEMBLY mode is provided in the intermediate position
between C-IN and Harf LOAD. As the C-IN (Cassette IN) mode
is usually set when a cassette tape is ejected, the ASSEMBLY
mode should be entered after entering the C-IN mode.
Fig. 2-2-1
Table 2-2-1
There are 2 ways to set to ASSEMBLY mode as shown below:
1) Apply DC 3 V to the motor.
2) Remove the motor from the bracket (Gear cover) and turn
the wheel gear 2 using screwdriver.
As shown in Fig. 2-2-1, the ASSEMBLY mode position refers to
where the hole position of 7 cm component matches the hole
position of the main deck.
34 Encorder gear
assembly
See section 2.7.16
36 Arm gear 1 assembly
See section 2.7.16
Main deck
39 Arm gear 2 assembly
See section 2.7.17
38 Sub cam See
section 2.7.17
40 Clutch lock lever assembly
See section 2.7.17
37 Centering arm assembly
See section 2.7.16
35 Main cam
See section 2.7.16
Main deck
Hole of Arm gear
1 assembly
Hole of Arm gear
2 assembly
Hole of Encode gear
Hole of Main cam gear
Hole of Centering arm assembly
Hole of Clutch lock
lever assembly
Hole of Sub cam
gear assembly
Top view
Bottom view
Phase alignment