Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01, Руководство пользователя

Страница: 91 / 104

APPENDIX A
Rack-Mounting the NSMXpress Series II
Appliance
This appendix lists the rack types and describes the procedures for mounting the
NSMXpress Series II appliances on the Juniper UNIMOUNT rack-mount systems..
• Rack-Mounting the NSMXpress Series II Appliance on page 71
Rack-Mounting the NSMXpress Series II Appliance
This section lists the rack types and describes the procedures for mounting the NSMXpress
Series II appliances on the Juniper UNIMOUNT rack-mount systems.
The NSMXpress Series II appliance supports the following rack types:
•
19” 4-post rack
• 19" 2-post rack
The rack-mount system is flexible and offers several options for rack-mounting the
hardware. The different options include:
NOTE: If you are installing multiple NSMXpress Series II appliances in one
rack, you should install the lowest one first and proceed upward in the rack.
Install heavier NSMXpress Series II appliances in the lower part of the rack.
• Front-Mounting Flush to Rack on page 71
•
Front-Mounting Recessed in Rack on page 72
•
Front-Rear-Mounting Flush to Rack on page 73
• Front-Rear- Mounting Recessed in Rack on page 73
• Mid-Mount in Two Post Equipment Rack on page 74
Front-Mounting Flush to Rack
To mount the appliance using this option:
1.
Attach the chassis to the equipment rack using 4 rack-mount screws on each side of
the system. See Figure 53 on page 72.
71 Copyright © 2010, Juniper Networks, Inc.