Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01, Руководство пользователя

Страница: 33 / 104

To start system setup manually, type:
nsm_setup
for operation of NSM server, switch to user “nsm”.
Please consult NSM product documentation for details.
[admin@NSMXpress ~]$
2.
Log in using your “admin” user name and password.
3.
Enter nsm_setup at the prompt.
4.
Enter your password and press Enter.
5.
From the Settings menu:
•
For a regional server, enter 9 , and then enter 1 to display the NSM Configuration
Main Menu for typical settings, or enter 2 for custom settings.
• For a central manager, enter 9 to display the Configuration Main Menu.
Configuring the NSM Software
After you log in as an “admin” user, an initial setup script walks you through additional
configuration system settings before finalizing the NSM installation. This section describes
that setup process.
The steps in this procedure assume you:
• Have completed all appropriate steps in “Getting Started” on page 3.
•
Have a console terminal or terminal emulation utility running.
•
See the following command output in the emulation utility window:
Your NSMXpress is now active on the network.
To configure your system via a web browser, connect to:
https://10.150.43.205/administration
To configure your system via command line, type:
nsm_setup
For operation of NSM server, switch to user “nsm”
Please consult NSM product documentation for details.
[admin@NSMXpress “]$
Your NSMXpress Series II appliance comes preconfigured as a regional server or a central
manager, as described in the following sections:
•
Configuring a Regional Server on page 14
• Configuring the Central Manager on page 19
13 Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Installing and Configuring NSM from the CLI