Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01, Руководство пользователя

Страница: 92 / 104

2.
Verify that the mounting screws on one side of the rack are aligned with the mounting
screws on the opposite side and that the appliance is level.
Figure 53: Front-Mounting flush to rack
Front-Mounting Recessed in Rack
This option allows sites with no front-of-rack clearance to recess the NSMXpress Series
II system in the equipment rack.
To mount the appliance using this option:
1.
Remove the rear screws on each side of the system’s front rails and the two small
screws towards the front of the chassis.
2.
Loosen the side rail screws of the chassis and slide the front rails of the system forward,
as far as they will move. See Figure 54 on page 72.
3.
Tighten the side rail screws. Insert the two small screws in the recessed holes on the
front rails and tighten.
4.
Insert 4 rack-mount screws on each side of the system to secure the chassis to the
rack-mount system.
5.
Verify that the mounting screws on one side of the rack are aligned with the mounting
screws on the opposite side and that the appliance is level.
Figure 54: Front-Mounting recessed in rack
Copyright © 2010, Juniper Networks, Inc. 72
NSMXpress Series II User Guide