Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01, Руководство пользователя

Страница: 29 / 104

Set Up Your Appliance
This section provides the minimum information necessary to make your appliance active
on the network.
To set up your appliance either as a regional server or a central manager, follow these
steps:
1.
Enter the IP address for interface eth0 and press Enter.
2.
Enter the subnet mask for interface eth0 and press Enter.
3.
Enter the default route or default gateway address for interface eth0 and press Enter.
Applying changes...
Re-loading database
ip_tables: (C) 2000–2002 Netfilter core team
ip_tables: (C) 2000–2002 Netfilter core team
ip_tables: (C) 2000–2002 Netfileter core team
Done!
Your NSMXpress is now active on the network.
To configure your system via a web browser, connect to:
https://10.150.43.205/administration
To configure your system via command line, type:
nsm_setup
For operation of NSM server, switch to user “nsm”.
Please consult NSM product documentation for details.
[admin@NSMXpress ~]$
To complete the setup process using the CLI, go to “CLI Configuration” on page 9. To
complete the setup process using the Web interface, go to “Web Interface Configuration”
on page 10.
CLI Configuration
To finish initial setup from the CLI, use the following steps. If you are logged in, enter
nsm_setup at the command prompt.
If you are not logged on, follow these steps:
1.
Enter your admin username, and then press Enter.
2.
Enter your password and then press Enter.
Juniper NSMXpress OS build 2.105498
NSM 2010.4r1Kernel 2.6.9–55.0.2.ELsmp on an i686
NSMXpress.Juniper.net login: admin
Password:
Last login: Tue May 27 17:20:25 on ttyS0
Run NSMXpress system setup? [y/N]
3.
Enter y to run the system setup program from the CLI.
9 Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Getting Started