Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01, Руководство пользователя

Страница: 28 / 104

Table 7: RJ-45 Console Connector Pinout (continued)
Description Signal Pin
Clear to Send CTS Input 8
Initial Setup Configuration
When you first turn on an unconfigured NSMXpress Series II appliance, you need to enter
basic network and machine information through the serial console to make your appliance
accessible to the network. After entering these settings, you can continue configuring
the appliance using the CLI or the Web interface. You are not prompted for the initial
setup information again.
This section describes the required serial console setup and the tasks you need to perform
when connecting to your NSMXpress Series II appliance for the first time:
•
Boot NSMXpress Series II on page 8
•
Set Up Your Appliance on page 9
Boot NSMXpress Series II
To configure NSMXpress Series II for the first time, you must attach your NSMXpress
Series II appliance to a console terminal running an emulation utility such as
HyperTerminal.
1.
Configure a console terminal or terminal emulation utility to use the following serial
connection parameters:
•
9600 bits per second
• 8-bit no parity (8N1)
•
1 stop bit
•
No flow control
2.
Connect the terminal or laptop to the console cable plugged into the NSMXpress
Series II appliance console port.
3.
Turn on the NSMXpress Series II appliance.
When the NSMXpress Series II appliance is powered on, the serial console displays
diagnostic information before proceeding to the boot countdown. When complete,
the serial console displays the login prompt terminal emulator.
NSMXpress.juniper.net login:
4.
Enter admin as your default login name.
5.
Enter abc123 as your default password.
6.
Change your default password when prompted. Enter the default password first,
followed by your new password. All passwords are case-sensitive.
Copyright © 2010, Juniper Networks, Inc. 8
NSMXpress Series II User Guide