Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01, Руководство пользователя

Страница: 94 / 104

4.
Slide the rear mount rail brackets into the backs of the front rails on either side of the
chassis and align with your rear equipment rack posts. Secure the rear mount rail
brackets to your equipment rack with 2 rack mount screws each. See Figure 56 on
page 74.
5.
Insert locking screws on the sides of the rear mount brackets to secure the front and
rear mounting brackets in place.
6.
Verify that the mounting screws on one side of the rack are aligned with the mounting
screws on the opposite side and that the appliance is level.
Figure 56: Front-Rear-Mounting recessed in rack
The recessed position allows network and console cables to be routed through the sides
of the equipment rack and throught the holes of the recessed front rails on either side of
the unit. This enables easy cable routing on the racks with limited cable management.
Mid-Mount in Two Post Equipment Rack
This option is suitable for a two post equipment rack. It allows the appliance to be
mid-mounted so that there is even clearance on the front and rear of the rack.
To mount the appliance using this option:
1.
Remove the two front mount rails from either side of the chassis.
2.
Insert one mid-mount bracket to the center on either side of the chassis.
3.
Attach the chassis to the equipment rack and insert the other two mid-mount brackets
on either side of the system to secure the chassis to the backs of the post. See Figure
57 on page 75.
4.
Verify that the mounting screws on one side of the rack are aligned with the mounting
screws on the opposite side and that the appliance is level.
Copyright © 2010, Juniper Networks, Inc. 74
NSMXpress Series II User Guide