Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01, Руководство пользователя

Страница: 26 / 104

Installing the NSMXpress Series II Hardware
Follow these steps to unpack theNSMXpress Series II appliance and connect it to your
network.
To install NSMXpress Series II:
1.
Place the shipping container on a flat surface and remove the hardware components
with care.
2.
Remove the NSMXpress Series II device from the shipping container and place it on
a flat surface.
3.
Mount NSMXpress Series II in your server rack using the attached mounting brackets.
4.
Plug the power cord into the AC receptacle on the rear panel.
Figure 1: Rear Panel of NSMXpress Series II
g040042
Power
supply AC Power
supply
receptacle
AC Power Blank power
supply tray
switch
Fan 0 Fan 1
If your NSMXpress contains two power supplies, plug a power cord into each AC
receptacle.
5.
Plug the other end of the power cord into a wall socket.
If your NSMXpress Series II contains two power supplies, plug each power cord into
a separate power circuit to ensure that the NSMXpress Series II continues to receive
power if one of the power circuits fails.
6.
Plug the Ethernet cable into the network port marked ETH0 on the front panel. See
Figure 2 on page 6.
Figure 2: Front Panel of NSMXpress Series II
CONSOLE ETH1 ETH0
g040404
Power
LED
Hardware
LED
Hard disk LED
Left
LAN
LED
Right
LAN
LED
NSMXpress II
Hard disk
Activity LED
Hard disk
Failure LED
Network ports
Console
port
USB
maintenance
port
Copyright © 2010, Juniper Networks, Inc. 6
NSMXpress Series II User Guide