Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01, Руководство пользователя

Страница: 68 / 104

Figure 32: Edit RADIUS Server Dialog Box
3.
Edit the parameters you want to change and click Save .
Monitoring with SNMP
You can configure NSMXpress Series II for SNMP monitoring from a network operations
server. The server can then issue periodic SNMP Get instructions to return the status of
the NSMXpress Series II appliance.
You configure SNMP on NSMXpress Series II appliances with access credentials for either
SNMP v2c or SNMP v3. NSMXpress Series II appliances support read-only access to the
System Descriptor (sysDescr) and Host Resource MIB.
This section provides instructions for configuring NSMXpress Series II for SNMP monitoring.
You must provide access credentials for the SNMP server, a list of IP addresses from
which logon requests will be accepted, and the trap conditions to be reported to the
SNMP server.
To configure SNMP monitoring of your NSMXpress Series II appliance, select System
Administration > SNMP Monitoring . The SNMP window appears. This window contains
the tabs described in the following sections:
• SNMP Configuration on page 48
•
SNMP System Information on page 49
•
SNMP Trap Configuration on page 50
SNMP Configuration
To configure SNMP:
1.
Select System Administration > SNMP Monitoring .
2.
Select the SNMP Config tab, which is shown in Figure 33 on page 49.
Copyright © 2010, Juniper Networks, Inc. 48
NSMXpress Series II User Guide