JUMO 406060, Руководство по эксплуатации

Страница: 84 / 116

12 Specification
84
12.3 JUMO flowTRANS MAG S10 – Material load
for process connections
The limits of the permissible measuring medium temperature
(T
medium
) and permissible pressure (P
medium
) are calculated on
the basis of the liner and flange material used in the device (see
device name plate).
12.3.1 Minimum permissible operating pressure
The minimum permissible operating pressure (P
medium
)
dependent on the temperature of the medium being measured
(T
medium
) and the liner material is indicated in the table below.
Sensor, variant 1
Liner material Nominal diameter P
medium
[mbar abs]
T
medium
*
Hard rubber DN 15 to 2000
(½ to 80 in.)
0 < 85 °C (185 °F)
Soft rubber DN 50 to 2000
(2 to 80 in.)
0 < 60 °C (140 °F)
PTFE DN 10 to 600
( ⅜ to 24 in.)
270
400
500
< 20 °C (68 °F)
< 100 °C (212 °F)
< 130 °C (266 °F)
PFA DN 3 to 200
(¹ ⁄ ₁₀ to 8 in.)
0 < 130 °C (266 °F)
ETFE DN 25 to 600
(1 to 24 in.)
100 < 130 °C (266 °F)
Sensor, variant 2
Liner material Nominal diameter P
medium
[mbar abs]
T
medium
*
Hard rubber DN 40 to 600
(1 ½ to 24 in.)
600 < 80 °C (176 °F)
PTFE DN 25 to 600
(1 to 24 in.)
270
400
500
< 20 °C (68 °F)
< 100 °C (212 °F)
< 130 °C (266 °F)
* For CIP/SIP cleaning, higher temperatures are permitted for limited periods;
refer to table Maximum permissible cleaning temperature on page 87.
Approvals for liners available on request; please contact the
manufacturer.
12.3.2 Material load
Sensor, variant 1
Figure 54: DIN flange, stainless steel up to DN 600 (24 in.)
Figure 55: ASME flange, stainless steel up to DN 400 (16 in.) (CL150/300) and up to
DN 1000 (40 in.) (CL150)