5 Installation
19
5.1.10 Free inlet or outlet
Figure 16: Free inflow and outflow
A
For a free outflow, do not install flowmeter at the highest point
of the piping or on its outflow side, since the measuring tube
may run empty, creating air bubbles.
B
For free inflow/outflow, provide an invert to make sure that the
piping is always full
5.1.11 Mounting with heavily contaminated
measuring media
Figure 17: Bypass line
For strongly contaminated measuring media, a bypass line in
accordance with the figure is recommended so that operation of
the system can continue to run without interruption during
mechanical cleaning.
5.1.12 Mounting with pipe vibration
1
Pump
2
Damping device
3
Turn-off device
Figure 18: Vibration damping
If pipe vibration occurs, it needs to be damped using damping
devices.
The damping devices must be installed outside the support
section and outside of the piping section between the turn-off
devices.
Avoid connecting damping devices directly to the flowmeter
sensor.
Содержание 406060
