JUMO 406060, Руководство по эксплуатации

Страница: 57 / 116

7 Operation
57
7.5.4 Menu: Device Setup
Menu / Parameters Description
Device Setup
...Access Control Used to select the “...Access Control” submenu with .
...Sensor Used to select the “...Sensor” submenu with .
...Transmitter Used to select the “...Transmitter” submenu with .
Device Setup / ...Access Control
Standard Password Used to enter / change the password for the “Standard” access level.
Read Only Switch Used to indicate the position of the write-protection switch.
Further information can be found in the chapter on Write-protection switch, service LED and local operator interface on
page 36.
Device Setup / ...Sensor
Range Mode Config Used to activate the second measuring range for mass flow and volumetric flow.
The setting can be made separately for the mass flow (Qm) and the volumetric flow (Qv). This enables you to quickly toggle
between two measuring ranges (e. g. Qm max and Qm max2). The change-over occurs via the “Qm Range Mode” and “Qv
Range Mode” parameters.
• Disabled: Used to deactivate the second measuring range for mass flow and volumetric flow.
• Qm and Qv: Used to activate the second measuring range for mass flow and volumetric flow.
• Qm only: Used to activate the second measuring range for mass flow.
• Qv only: Used to activate the second measuring range for volumetric flow.
Qm Max DN Maximum mass flow rate for the selected nominal diameter at a velocity of 10 m/s.
The value is set automatically based on the selected nominal diameter.
Qm Max 1 Used to set the full-scale value 1 (measuring range = 0 to Qm Max 1 ) for the upstream and downstream mass flow.
Default setting: 1 x Q
max
DN
Qm Max 2 Used to set the full-scale value 2 (measuring range = 0 to Qm Max 2 ) for the upstream and downstream mass flow. This
value is also used for determining the corresponding percentage value. This parameter is only available if for the “Qm Range
Mode” parameter setting the “Qm Max 2” value was selected.
Qm Range Mode Used to manually toggle between the measuring ranges (Qm Max 1 / Qm Max 2) for measuring the mass flow. This
parameter is only available if for the “Range Mode Config” parameter setting the Qm and Qv value or the Qm only value was
selected.
Qv Max DN Maximum volumetric flow rate for the selected nominal diameter at a velocity of 10 m/s.
The value is set automatically based on the selected nominal diameter.
Qv Max 1 Used to set the full-scale value 1 (measuring range = 0 to Qv Max 1 ) for the upstream and downstream volumetric flow rate.
Default setting: 1 x Q
max
DN
Qv Max 2 Used to set the full-scale value 2 (measuring range = 0 to Qv Max 2 ) for the upstream and downstream volumetric flow rate.
This value is also used for determining the corresponding percentage value. This parameter is only available if for the “Qv
Range Mode” parameter setting the “Qv Max 2” value was selected.
Default setting: 1 x Q
max
DN
Qv Range Mode Used to manually toggle between the measuring ranges (Qv Max 1 / Qv Max 2) for measuring the volumetric flow. This
parameter is only available if for the “Range Mode Config” parameter setting the Qm and Qv value or the Qv only value was
selected.
Sensor Location Tag Used to enter the meter location for the sensor.
Alphanumeric, max. 20 characters
Sensor Tag Used to enter the TAG number of the sensor.
Alphanumeric, max. 20 characters.
...Operating Mode Used to select the “...Operating Mode” submenu with .