JCM GAMMA VERSUS M20, Руководство пользователя

Страница: 99 / 111

GAMMA VERSUS MANUAL
99
COD. 1257066 Gamma VERSUS Manual v1.13
Memorizing RB3
The receiver can memorize up to 6 transmitters RB3 (3 for security on closing and 3 for security on opening).
Before memorizing, place the options selectors in the desired position. Any subsequent changes will entail
reprogramming.
Press PROG button and keep pressed until desired mode selected. Then follow the steps above.
Memorizing of one safety transmitter (IN1 input)
Mode Configuration of transmitter memorizing in the receiver. Led R1 Led R2
1 Safety edge activates relay 1 on the receiver ON OFF
2 Safety edge activates relay 2 on the receiver OFF ON
3 Safety edge activates the two relays 1 and 2 at the same time ON ON
Memorizing of two safety transmitters (IN1 and IN2 input)
Mode Configuration of transmitter memorizing in the receiver. Led R1 Led R2
4 Safety edge in IN1 activates relay 1 and safety edge in IN2 activates
relay 2 (with switch SW1: 2 to OFF, the IN2 input is not tested) Flashing Flashing
Note: If you change the options selectors and the sensitivity after memorizing the safety devices, you must return to
memorize these devices for the changes to take effect.
System programming
After memorizing of the desired transmitter, perform the programming of the control panel with the security
element memorized. See
programming
section on control panel user’s manual.
Note: If you change the position of transmitter RS3, you must perform the system programming again, otherwise
RS3 will indicate a safety error, and the door will not work properly.
Maintenance
Table of message/error indication beeps and leds
LEDs perform a flash every 5 seconds, indicating that the equipment has a good power supply.
Equipment D1/D2
Leds
Check Led Beeps Message / error Solution
RSEC3 OFF OFF 4 beeps
every 20
seconds
Indicates RS3 transmitter low
battery when trying to begin a
manoeuvre
Verify the batteries of the
transmitter
RSEC3 OFF OFF 4 beeps
every 20
seconds
Communication failure between
RSEC3 and RS3 transmitter when
trying to begin a manoeuvre
Verify the radio signal with the
Check function.
RSEC3 --- --- 14
continuous
beeps
You are trying to store an RS3 and
already has a RB3 stored, or vice
versa.
Reset receiver's memory and store
the desired device.
RSEC/R in
Check mode
OFF Led
flashing
according
coverage
table
1 beeps
every 5
seconds
Communication via radio OK
between RSEC3 and RB3
transmitter
---
RSEC/R in
Check mode
OFF 3 beeps
every 5
seconds
Communication failure between
RSEC3 and RB3 transmitter
Verify the radio signal with the
Check function.
VERSUS
Control
panel
Led ERR
ON No beeps Any error Use VERSUS-PROG to know the
number of error