JCM GAMMA VERSUS M20, Руководство пользователя

Страница: 19 / 111

GAMMA VERSUS MANUAL
19
COD. 1257066 Gamma VERSUS Manual v1.13
5C
Switch 9 28 FIXED FLASH Configuration to fix flash output to use electronic flash lights
29 CHARGE
MANEUVER
Configuration to enable charge maneuver every 1 hour during 3 seconds.
30 AUTOMATIC
FIRE OPEN
Enables the automatic opening due to the deactivation of the fire alarm signal.
31 DM
BUTTON&RADIO
Configuration dead man function by using buttons or radio (active in OFF
position)
32 CLOSING DM
MODE
Configuration dead man mode forced in closing maneuver
DB
Switch 10
(*) This function is special and only available in CBX control panel.
4.3.2 Jumpers
Jumper Function
JP If cut off does not allows Side-prog programming
4.4 Input parameters
The input parameters allow configuring each available input of the control panel. Each input can have different
values; they are indicated on the third column of the following table.
Num Inputs Available values - description
5E
IN 1:IN10
0 NO FUNCTION The input has not got a defined function.
1 S.EDGE.CL Closing safety edge input (8k2) .
2 S.EDGE.OP Opening safety edge input (8k2).
5 FC.OP M1 M1 motor opening limit switch input (NC).
6 FC.OP M2 M2 motor opening limit switch input (NC).
7 FC.CL M1 M1 motor closing limit switch input (NC).
8 FC.CL M2 M2 motor closing limit switch input (NC).
9 SEC.OP Opening security contact input (NC).
10 SEC.CL Closing security contact input (NC).
11 STOP Stop pushbutton input (NC).
12 START Start pushbutton input (NO).
13 OPEN Open pushbutton input (NO).
14 CLOSE Close pushbutton input (NO).
15
PEDESTRIAN
START
Pedestrian pushbutton input (NO).
16
PEDESTRIAN
OPEN
Open pedestrian pushbutton input (NO).
17 DEAD MAN OPEN Open pushbutton input in deadman mode (NO).
18 DEAD MAN CLOSE Close pushbutton input in deadman mode (NO).
19 DEAD MAN OP-CL Start pushbutton input in deadman mode (NO).
20 HALL_A MOTOR 1 HALL A for M1 motor input
21 HALL_B MOTOR 1 HALL B for M1 motor input
22 HALL_A MOTOR 2 HALL A for M2 motor input
23 HALL_B MOTOR 2 HALL B for M2 motor input
24 ZERO CROSS Configuration input as zero pass.
25 PROG Programming pushbutton input PROG.
26 CURRENT MOTOR
1
Configuration input as current motor 1.
5F
60
61
62
63
64