JCM GAMMA VERSUS M20, Руководство пользователя

Страница: 29 / 111

GAMMA VERSUS MANUAL
29
COD. 1257066 Gamma VERSUS Manual v1.13
7.2 Hall or time mode function
Model
Time mode (all) and Hall mode (M20,M30)
Associated
parameters
ID Description Type
P0D HALL mode ON/OFF
P0E Time mode ON/OFF
P33 Opening stop point NUMERIC
P34 Closing stop point NUMERIC
PCB Opening stop point motor 2 (M22) NUMERIC
PCC Closing stop point motor 2 (M22) NUMERIC
Description VERSUS control panels can work either by time or by Hall.
Configuration To enable Time or Hall modes it is necessary to set to ON the associated parameters
(
P0D or P0E parameters) by means of a VERSUS-PROG programming tool. It is also
possible to enable or disable these functions by setting the mode Time/HALL function to
an option switch. Enabling Time mode implies disabling the Hall mode and vice versa.
Operating After configuring the working mode, the control panel will use Time or Hall signal as a
position reference.
Notes The main maneuver parameters that define its duration are the P33 and P34
configuration parameters (in addition to PCB and PCC in M22 model for second motor).
The opened and closed positions are the starting points and they always take the 0
value.
P33 parameter configures the opening stop point (opening maneuver duration)
and the P34 parameter configures the closing stop point (closing maneuver duration).
The PCB parameter sets the opening stop point for motor 2 (duration of opening
operation) and the PCC parameter sets the closing stop point for motor 2 (duration of the
closing) (model M22).
According to the selected working mode, all the position parameters will use a certain
position units. In case of Hall mode, these units are pulses and in case of time mode,
seconds or milliseconds will be used. By means of a VERSUS-PROG programming tool
it is possible to see these position units.
P33 Opening stop point
Opening starting
point (always 0)
P34 Closing stop
point
Closing starting
point (always 0)