JCM GAMMA VERSUS M20, Руководство пользователя

Страница: 58 / 111

GAMMA VERSUS MANUAL
58
COD. 1257066 Gamma VERSUS Manual v1.13
7.22 Panic function
Model
All
Associated
parameters
ID Description Type
P78…P90 OUT XX OUTPUT
PA1…PB0 (TL-CARD-V) OUT XXX OUTPUT
P50 Panic active signal NUMERIC
Description The panic function allows activating a special output by pressing during several
seconds a transmitter button. This transmitter has to be programmed on any of the 4
available Motion channels of the control panel integrated receiver.
This can be used to inform a dangerous or emergency situation by means of a
transmitter (thief, medical emergency, etc.)
Configuration To enable the panic function it is needed to configure any of the available outputs as
“Panic” by means a VERSUS-PROG programming tool. The
P78 to P90 configuration
parameters are used to configure the control panel outputs and the PA1 to PB0
configuration parameter are used to configure the TL-CARD-V extra outputs.
The configured “Panic” outputs will be activated (pulse output) in case of transmitter
long activation is detected. Therefore these outputs can be used to activate any kind of
alarm system. The output is “normally opened” and it changes to “normally closed”
when it is activated. It keeps active for a short period of time (pulse).
To configure the time that is needed to press the transmitter button to activate the
panic signal,
P50 parameter can be used. This parameter can take values from 0 to 20
seconds.
Operating If any output is configured as “Panic” and a transmitter is programmed on any of the 4
available Motion channels, the control panel checks the holding time of the transmitter
button.
If this time is larger than the configured time it activates the “Panic” outputs to inform
about a dangerous situation.
Notes As this function uses the transmitter button holding time to activate an emergency
output, radio interferences have to be taken into account, because they can affect to
the “transmitter – control panel” communication.