JCM GAMMA VERSUS M20, Руководство пользователя

Страница: 28 / 111

GAMMA VERSUS MANUAL
28
COD. 1257066 Gamma VERSUS Manual v1.13
7. VERSUS FUNCTIONS
7.1 Autoprogramming function
Model All (except M22 model)
Associated
parameters
ID Description Type
P01 Autoprogramm ng ON/OFF
Description The autoprogramming function allows programming the control panel maneuvers by
means of a single user action (by pressing control panel button START/OPEN or
transmitter).
Configuration To enable the autoprogramming function, it is needed to set to ON the P01 configuration
parameter by means of a VERSUS-PROG programming tool. It is also possible to enable
or disable this function by setting the “Autoprogramming ON/OFF” function to an option
switch.
Operating If the autoprogramming function is enabled when the maneuver is programmed a single
user action is needed. After this user action, the control panel automatically executes the
opening and closing maneuvers. During these maneuvers the control panel searches
and stores the opened/closed point references. Finally, the control panel exits the
programming mode automatically.
Notes The autoprogramming function can not be enabled if it is not possible to find an
opened/closed point reference (this means, if no limit switches inputs or mechanical stop
are present).
If this function is enabled, after the programming sequence the autoclosing timeout is set
by default to 30 seconds. In addition the pedestrian maneuver is set by default to 1/3 of
the main maneuver. Finally, in case of slow speed mode, the slow speed run will be a
15% of the main maneuver.
Autoclose 30s
Pedestrian 1/3
Slow speed
opening 15%
Slow speed closing
15%