JCM GAMMA VERSUS M20, Руководство пользователя

Страница: 46 / 111

GAMMA VERSUS MANUAL
46
COD. 1257066 Gamma VERSUS Manual v1.13
7.13 Backjump function
model. If control panel output maximum current is not enough some control panel
models have an auxiliary input (IN AUX) in order to supply extra current to the voltage
outputs. In this case an extra power supply must be used and connected to this
auxiliary input.
If free voltage output is used an external power supply is needed.
Model All
Associated
parameters
ID Description Type
P0F Backjump opening enable ON/OFF
P10 Backjump closing enable ON/OFF
P3C Backjump opening time NUMERIC
P3D Backjump closing time NUMERIC
Description The backjump function allows mechanically release the motor after the control panel
reaches the OPENED and CLOSE maneuver reference points.
Configuration To enable the backjump function it is needed to set the P0F configuration parameter to
ON in case of opening backjump or set the P10 configuration parameter to ON in case
of closing backjump by means of a VERSUS-PROG programming tool. .
Backjump opening and closing timers are configured by means of the P3C and P3D
configuration parameters. These parameters can take values from 0 seconds to
several seconds. The units used for this parameter are seconds.
Operating After backjump function is enabled, the control panel executes the backjump sequence
every time an opening or a closing maneuver finishes on the OPENED or CLOSED
reference points. After the door finishes the opening or closing maneuver, it changes
the movement direction during the configured backjump period in order to release the
motor.
P3D Backjump
closing time
P3C Backjump
opening time
Closing maneuver
time
Opening
maneuver time