SKYZER TECHNOLOGIES
PAGE 49 OF 140
INGENICO Tetra PTS190 Paymark Operating GuideVersion 1.02
6.7 EFTPOS Configuration for Multi-Merchant
For a multi-merchant terminal each merchant has its own configuration.
Prior to configuring the terminal for multi-merchant, refer to page 47 to setup
the required number of active merchants on the terminal. Once assigned then
proceed with the following steps to configure the terminal for multi merchant.
Step
Terminal Display
Comment
1.0
Press
FUNC
2.0
FUNCTION?
Enter
3824
and press
ENTER.
3.0
CONFIG PARAMS?
ENTER OR CLEAR
ENTER
to configure the parameters,
CLEAR
to cancel and exit to idle prompt.
4.0
1 MERCHANT 1
2 MERCHANT 2
3 MERCHANT 3
Select the corresponding number on the terminal to select the Merchant to proceed
with configuration followed by
ENTER
.
5.0
TERMINAL ID?
XXXXXXXX
This parameter specifies the Terminal ID that Paymark assigns to the terminal.
Press
ENTER
.
6.0
MERCHANT ID?
XXXXXXXXXXX
This parameter specifies the Merchant ID assigned by Paymark.
Press
ENTER
.
7.0
NII?
001
This parameter specifies the Network International Identifier (by default 001) that
the terminal uses to route messages to Paymark.
Press
ENTER.
8.0
COMMS MODE?
1-DIAL-UP
To configure COMMS mode:
Press
1
for
Dial-up configuration
followed by
ENTER
and proceed with the
configuration as on page 26.
2-TCP-IP / DIAL
Press
2
for
TCP-IP/Dial as backup configuration
followed by
ENTER
and
proceed with the configuration as on page 27.
3-TCP-IP
Press
3
for
TCP-IP configuration
followed by
ENTER
and proceed with the
configuration as on page 29.
4-GPRS
Press
4
for
GPRS configuration
followed by
ENTER
and proceed with the
configuration as on page 30.
