SKYZER TECHNOLOGIES
PAGE 39 OF 140
INGENICO Tetra PTS190 Paymark Operating GuideVersion 1.02
7.0
DNS1 IP ADDR
XXX.XXX.XXX.XXX
Enter in the gateway IP address to forward the packets from.
Example: 192.10.1.1
8.0
DNS2 IP ADDR
XXX.XXX.XXX.XXX
Enter in the gateway IP address to forward the packets from.
Example: 192.10.1.1
9.0
GPRS PRIMARY
HOST PORT
33876
This parameter specifies the GPRS Primary Port Number of Paymark network. By
default the host port number is set to
33876
.
10.0
GPRS SECONDARY
HOST PORT
33876
This parameter specifies the GPRS Secondary Port Number of Paymark network. By
default the host port number is set to
33876
.
11.0
QUICK DIAL?
1-YES 2-NO
This parameter sets up the speed of the terminal to dial. By default is selected as
1-
YES
or press
2-NO
to disable quick dial.
12.0
DIAL MODE?
1-TONE
2-PULSE
3-TONE/BLIND
4-PLUSE/BLIND
This parameter sets up the way that the terminal dials. Select the preferred mode
by pressing the corresponding number key.
1 = Tone
- is the default setting.
In the default dial mode setting
1
(Tone), the terminal uses DTMF tones to dial the
number, but only after detecting a valid NZ dial tone. If a valid dial tone isn’t
detected, “Transmission Error” will be displayed.
2 = Pulse Dial
– this communication setting is used for the older PABX systems
and is rarely used nowadays.
3 = Tone/Blind Dial
– this is the same as Tone dial, however the modem ignores
the health of the dial tone on the line and simply dials the configured phone number
to call the host. This is used where the quality of the dial tone is low.
4 = Pulse/Blind Dial –
this communication setting is used for the older PABX
systems and is rarely used nowadays.
13.0
PABX?
1A
or
1W
Press
ENTER
to bypass if no PABX prefix is required.
This parameter specifies the PABX numbers that the terminal dials to access an
outside line.
Note:
The terminal pauses for 1 second after dialling if a control character
‘A’
is
inserted or to pauses for couple of seconds after dialling if a control character
‘W’
is
inserted after the PABX number. To insert a control character
‘A’ or ‘W’
, press the
corresponding number key and then the
FUNC
key.
To remove a PABX number from the PABX field, press
1
and then press
FUNC
key
until space is displayed followed by
ENTER
.
14.0
HOST PHONE NO?
08797
This parameter specifies the phone number of Paymark network to dial to. By
default, the host phone number is set as
08797
. Press
ENTER
.
NOTE: If the merchant has the Toll Bar on the site, then key in this phone
number 1797 to obtain connectivity to Paymark network.
