SKYZER TECHNOLOGIES
PAGE 26 OF 140
INGENICO Tetra PTS190 Paymark Operating GuideVersion 1.02
6 EFTPOS Configuration
The EFTPOS Configuration option enables the terminal to be configured to
operate as an EFTPOS terminal and must be done before the terminal can
process transactions.
Step
Terminal Display
Comment
1.0
Press
FUNC
2.0
FUNCTION?
Enter
3824
and press
ENTER.
3.0
CONFIG PARAMS?
ENTER OR CLEAR
ENTER
to configure the parameters or
CLEAR
to cancel and exit to idle prompt.
4.0
TERMINAL ID?
XXXXXXXX
This parameter specifies the Terminal ID assigned by Paymark. Key in the 8 digit
terminal ID and press
ENTER
.
5.0
MERCHANT ID?
XXXXXXXXXXX
This parameter specifies the Merchant ID assigned by Paymark. Merchant ID will be
automatically configured once terminal ID is keyed in. Press ENTER to confirm the
merchant ID is correct and if not, it can be manually over written.
6.0
NII?
001
This parameter specifies the Network International Identifier (
by default 001
) that
the terminal uses to route messages to Paymark. Press
ENTER.
7.0
COMMS MODE?
1-DIAL-UP
Select the preferred COMMS mode by pressing the corresponding number key. By
default
3-TCP-IP
is always selected.
Press
1
for
Dial-up configuration
followed by
ENTER
and proceed with the
configuration.
2-TCP-IP / DIAL
Press
2
for
TCP-IP/Dialup as backup configuration
followed by
ENTER
and
proceed with the configuration.
3-TCP-IP
Press
3
for
TCP-IP configuration
followed by
ENTER
and proceed with the
configuration.
4-GPRS
Press
4
for
GPRS configuration
followed by
ENTER
and proceed with the
configuration.
5-GPRS / DIAL
Press
5
for
GPRS/Dialup as backup configuration
followed by
ENTER
and
proceed with the configuration.
6-TCP-IP / GPRS
Press
6
for
TCP-IP/GPRS as backup configuration
followed by
ENTER
and
proceed with the configuration.
7-TCP-IP/GPRS/DIAL
Press
7
for
TCP-IP/GPRS/DIAL as backup configuration
followed by
ENTER
and proceed with the configuration.
8-DIAL/GPRS
Press
8
for
DIAL/GPRS as backup configuration
followed by
ENTER
and
proceed with the configuration.
