Idemia MorphoWave OEM, Руководство по установке

Страница: 19 / 112

MorphoWave
TM
OEM
– Installation guide
Section 1 : Introduction
2015_2000009096 V6
January 2019
IDEMIA D
OCUMENT
–
R
EPRODUCTION AND
D
ISCLOSURE
F
ORBIDDEN
19
Recommendations for terminal implementation
Every installation is unique. Sometimes the issues are well defined and can be handled
in a standard fashion; sometimes the issues are very specific and may not be
immediately recognizable.
IDEMIA recommends following these steps for a successful installation:

Plan the installation - Choose the type of hardware required, decide if a network is
required, and decide on the location and number of required terminals.

Unpack all items - Unpack all items and check against the packing list.

Install network hardware components - Install the cabling and components needed
to run the system.

Install software - Install the software needed to set up the terminals.

Pre-configure device - Connect the terminals to the Ethernet, supply power to the
terminals, and pre-configure the terminals.

Mount devices - Mount the terminals in their final locations

Power distribution and device hook up - Connect the terminals wiring via the back
panel of the MorphoAccess Sigma.

Power-up procedure - Check the power connections, verify if battery is attached
and then start the system safely. First Boot Assistant screen is displayed, where you
can perform fundamental configuration.
Note: The battery is for MorphoWave
TM
OEM terminal – Initial release only