IBS MediaClave, Руководство пользователя

Страница: 42 / 74

MediaClave overview
INTEGRA Biosciences
Page 36
4.3.3.6 Starting and running programs
1. Press WATERBATH on the start display. The WATER BATH PROG [#] screen appears
2. Press START
3. Open the safety cover and vessel lid
4. Press OK to continue the cycle
OR
Press
END to terminate the cycle
4.3.3.7 Flow of the WATERBATH cycle
The message PREPARE COOLING appears
All sensors are checked to ensure that they measure within the permitted temperature ranges. Sensors
are also checked for short-circuit, interruption and ice formation (< 2°C).
The pump runs for approximately five seconds to remove any trapped air.
Certain messages appear:
• WATER CONTROL (The water level is checked)
• HEAT UP
• WATERBATH ACTIVE
ATTENTION:
Ensure there is sufficient heating water in the vessel.
ATTENTION:
Pressing END results in the following alarmed screen message – CYCLE IS BEING CON-
CLUDED. The MAIN menu appears.
ATTENTION:
Install the cuvette (see section 3.2), and fill with approximately 2 L of water.
ATTENTION:
Press STEP to interrupt the cycle and proceed to the next step. The cycle cannot be in-
terrupted during cooling.
NOTE:
A progress printout is printed every x minutes during the sterilisation cycle (x refers to the selected
print cycle, see section 3.4.4.2).
NOTE:
The cycle progress is monitored and periodically updated on the screen.
NOTE:
The heat exchanger is filled with water to prevent overheating. The actual and target tempera-
tures are displayed in the upper right of the screen.
NOTE:
The actual temperature is displayed in the upper right of the screen. The duration is also dis-
played in minutes and seconds. The product is held at the target temperature for the specified time.