IBS MediaClave, Руководство пользователя

Страница: 39 / 74

User Manual 3.4
INTEGRA Biosciences Page 33
ENGLISH
OR
Press
CANCEL to reject all modifications and return to the PROGRAM menu
11. Press START to start the selected program (see section 4.3.2.9)
4.3.2.9 Starting and running programs
1. Open the safety cover and vessel lid
2. Press AUTOCLAVE on the start display. The AUTOCLAVE PROG [#] screen appears
3. Press START
4. Remove the cuvette from the vessel (see section 3.2)
5. Insert the steel base plate (see section 3.2.2.3)
6. Install the flexible temperature sensor (see section 3.2.2.2) and submerge it in the product
7. Close the vessel lid
8. Press OK to continue the cycle
OR
Press
END to terminate the cycle
9. Close the safety cover. The message PREPARE COOLING appears
• All sensors are checked to ensure that they measure within the permitted temperature ranges. Sen-
sors are also checked for short-circuit, interruption and ice formation (< 2°C)
• The pump runs for approximately five seconds to remove any trapped air
• WATER CONTROL appears on the screen. The water level is checked
• PRESSURE TEST appears on the screen
• The sterilisation cycle is started
4.3.2.10 Flow of the AUTOCLAVE sterilisation cycle
A series of messages appears:
ATTENTION:
Ensure there is sufficient heating water in the vessel. If there is insufficient heating water
in the vessel, the following alarmed message appears – TOO LITTLE HEATING WATER IN VESSEL .
Press END to confirm this error. The cycle is terminated.
ATTENTION:
Pressing END results in the alarmed message CYCLE IS BEING CONCLUDED . The
MAIN menu appears.
NOTE:
The safety cover lock ensures the safety cover is securely closed.
NOTE:
The heat exchanger is filled with water to prevent overheating. The actual and target temper-
atures are displayed in the upper right of the screen.
ATTENTION:
Press STEP to interrupt the cycle and proceed to the next step. The cycle cannot be in-
terrupted during cooling
NOTE:
A progress printout is printed every x minutes during the cycle (x refers to the selected print cycle,
see section 3.4.4.2).
NOTE:
The cycle progress is monitored and periodically updated on the GUI.