IBS MediaClave, Руководство пользователя

Страница: 19 / 74

User Manual 3.4
INTEGRA Biosciences Page 13
ENGLISH
3 Operating controls
3.1 Introduction
This chapter gives needed information to prepare the MediaClave for every operation mode.
3.2 Preparation for different operational modes
3.2.1 Mode MEDIACLAVE
3.2.1.1 Installing the Rigid Temperature Sensor
1. Unplug the flexible temperature sensor from the rear panel if installed
2. Unscrew the sensor from the vessel lid (using the fork wrench provided)
3. Insert the rigid temperature sensor and tighten it
4. Plug in to rear panel
3.2.1.2 Installing the Decanting tube
1. Press the silicone decanting tube onto the dispense fitting nipple which is located on the underside
of the vessel lid’s dispense port (see figure 2.1)
2. Attach the tube to the vessel lid by rotating the stainless steel securing nut clockwise until it is finger-
tight.
3.2.1.3 Installing the cuvette
1. Place the cuvette in the MediaClave vessel
2. Using both grips, turn the cuvette clockwise until it locks into position
3. The stirrer magnet bar must be installed into the cuvette
3.2.1.4 Filling the cuvette
1. Place the stirring magnet bar inside the cuvette. Position it on the pivot of the cuvette base
2. Add the desired amount of liquid or agar to the cuvette
ATTENTION:
Ensure that there is a O-ring attached to the temperature sensor.
ATTENTION:
It is essential that the stirrer magnet is installed properly. A stirrer magnet bar which
is missing or not properly installed may lead to inhomogeneous temperatures during the sterilisa-
tion process!