IBS MediaClave, Руководство пользователя

Страница: 13 / 74

User Manual 3.4
INTEGRA Biosciences Page 7
ENGLISH
2 Installation
2.1 Introduction
The purpose of this chapter is to give a step-by-step guide to the installation procedures of the Media-
Clave. It is divided into the sections
• Operating environment
• MediaClave drawings
• Electricity and water
• Filter and tubing installation
• Moving the MediaClave
2.2 Operating environment
In choosing an appropriate operating environment for the instrument, several factors must be considered.
• The operation of the MediaClave is allowed inside buildings only!
• The MediaClave must not be operated at places which are located higher than 2000 metres above
sea level!
• The chosen area must not present a hostile environment to the instrument or its intended use and
show
pollution degree l or ll .
• The ambient air temperature must be within 0 and 40°C . The maximum relative humidity for tempe-
ratures up to 31°C is 80% and then derates down to 50% at 40°C.
• The MediaClave must be placed on a clean, dry and horizontal surface which is capable of holding
at least 50kg. For user convenience and ease of access to the soft keys, the front edge of the instru-
ment must be positioned near the front of the bench. The instrument must be positioned in such a
way that the On/Off and power switches are always accessible.
• In case of voltage fluctuations, the INSTALLATION CATEGORIES (Overvoltage Categories) l, ll or lll
are authoritative!
For the mains supply, the minimum and normal category is ll.
• The instrument must be located within easy reach of electrical outlets, and provisions must be made
to run the outlet tubes at the rear of the instrument into waste receptacles.
These must be posi-
tioned lower than the Mediaclave over its whole length. (prevention of back pressure)
• Ensure all cables and tubes are positioned in a safe area to avoid people tripping over them.
• Do not place anything on the MediaClave safety cover. At the end of each cycle, or if a cycle is inter-
rupted and terminated, the safety cover opens automatically.
• Consult the local regulations before connecting the MediaClave to the drinking-water supply.
NOTE
: Refer also to the Installation Qualification (IQ) which provides additional information. It should be
consulted, if the MediaClave is installed first time or moved from one to another location.
WARNING
: Do not operate the instrument in an area that contains high concentrations of dust or humid-
ity, if there is a danger of explosion or if toxic chemicals are being used or stored nearby.
ATTENTION
: If water splatters to the front panel cannot be prevented, the provided printer cover must
be installed.