IBM x3105 - System - 4347, Руководство по обслуживанию, Страница: 47 / 130

Diskette drive problems
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v
See Chapter 3, “Parts listing, System x3105 Type 4347,” on page 53 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Symptom Action
The diskette drive activity LED
stays lit, or the server bypasses
the diskette drive.
1. If there is a diskette in the drive, make sure that:
v
The diskette drive is enabled in the Configuration/Setup Utility program.
v
The diskette is good and not damaged. (Try another diskette if you have
one.)
v The diskette is inserted correctly in the drive.
v The diskette contains the necessary files to start the server.
v The software is working correctly.
v The cable is connected correctly (in the correct orientation).
2. To prevent diskette drive read/write errors, make sure that the distance
between monitors and diskette drives is at least 76 mm (3 in.).
3. Run the diskette drive diagnostic test.
4. Reseat the following components:
a. Diskette drive cable
b. Diskette drive
c. (Trained service technician only) System board
5. Replace the components listed in step 3 one at a time, in the order shown,
restarting the server each time.
General problems
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, “Parts listing, System x3105 Type 4347,” on page 53 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v
If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Symptom Action
A cover lock is broken, an
indicator LED is not working, or
a similar problem has occurred.
If the part is a CRU, replace it. If the part is a FRU, the part must be replaced by a
trained service technician.
Chapter 2. Diagnostics
29