IBM x3105 - System - 4347, Руководство по обслуживанию, Страница: 107 / 130

Vacuum tool
Microprocessor
Socket
a. Squeeze and hold the bladder of the tool; then, place the suction cup on the
microprocessor and release the bladder.
Note: To maintain the correct orientation between the microprocessor and
the microprocessor socket during installation, align the
triangle-shaped indicator on one corner of the microprocessor with
the 45-degree angle on one corner of the socket.
b. Using the tool, carefully place the microprocessor into the socket.
c. Squeeze the bladder of the tool to release the microprocessor from the
suction cup.
3. Close the microprocessor retention latch and lock it securely in place.
Microprocessor
retention latch
4. Install the heat sink:
a. Make sure that the heat-sink retention lever is in the fully open position.
Important: Be careful when you handle the microprocessor and heat sink.
Do not contaminate the thermal material between them.
b. Slide the bottom edge of the heat sink under the lower flange of the
retention module; then, place the top of the heat sink onto the top of the
retention module.
c. Close the heat-sink retention lever and lock it securely in place.
5. Reconnect any cables that you disconnected during removal of the
microprocessor.
6. Install the microprocessor air baffle.
Chapter 4. Removing and replacing server components
89