IBM System x3650 M5, Инструкция по установке и обслуживанию, Страница: 838 / 1010

I.3818009 [I.3818009]
Explanation: The TPM could not be properly initialized. TPMINIT: Fail to initialize TPM chip.
Severity: Info
User response: Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to this error.
2. Reboot the system.
3. If the error continues, replace the system-board assembly (see Removing the system-board
assembly and Installing the system-board assembly).
I.3868000 [I.3868000]
Explanation:
IFM: System reset performed to reset adapters. IFM: System reset performed to reset adapters
Severity: Info
User response: Complete the following steps:
1. Information only; no action is required.
I.3868003 [I.3868003]
Explanation: IFM: Configuration to large for compatibility mode. IFM: Configuration too large for compatibility
mode
Severity: Info
User response: Complete the following steps:
1. Information only; no action is required.
I.5100B [I.5100B]
Explanation: An unqualified DIMM serial number has been detected: serial number % found in slot % of memory
card %. Unqualified DIMM Serial Number Detected
Severity: Info
User response: Complete the following steps:
1.
If this information event is logged in the IMM event log, the server does not have qualified memory installed.
2.
The memory installed may not be covered under warranty.
3. Without qualified memory, speeds supported above industry standards will not be enabled.
4. Please contact your Local Sales Representative or Authorized Business Partner to order qualified memory to
replace the unqualified DIMM(s).
5. After you intall qualified memory and power up the server, check to make sure this informational event is not
logged again.
I.3818009 • I.5100B
822
System x3650 M5 Type 5462: Installation and Service Guide