IBM System x3650 M5, Инструкция по установке и обслуживанию, Страница: 208 / 1010

Table 15. Non-supported adapters in the slot 3 and the slot 8 (continued)
Adapter description Option part number FRU part number
Qlogic 8200 Dual PORT
10GbE SFP+ Adapter for IBM
System x 90Y4600 90Y4605
Broadcom NetXtrme Dual
Port 10GbE SPG+ Adapter
for IBM System x 94Y5180 94Y5182
Mellanox ConnectX-3 10GbE
Adapter for IBM System x 00D9690 00D9692
Intel x520 Dual Port 10GbE
SFP+ Adapter for IBM
System x 49Y7960 49Y7962
Emulex VFA5 2x10GbE SFP+
Adapter for IBM System x 00JY830 00JY833
v
Any high-definition video-out connector or stereo connector on any add-on
video adapter is not supported
v
When you install any PCI adapter, the power cords must be disconnected from
the power source before you remove the PCI Express riser-card assembly.
Otherwise, the active power management event signal will be disabled by the
system-board logic, and the Wake on LAN feature might not work. However,
after the server is powered-on locally, the active power manager active power
management event signal will be enabled by the system-board logic.
v
Attention:
1. Do not install over 3 ServeRAID M1215 SAS/SATA controllers in one system.
2.
Do not install the NVIDIA Grid Kx/Mxx, the NVIDIA Quadro Kxxxx or the
NVIDIA Tesla Kxx adapter options in systems containing 1TB of system
memory or more. If these options are installed in systems with 1TB of
memory or more, it might cause undetected data corruption and system
instability. These options are only supported in systems containing less than
1TB of memory. For more information, see RETAIN tip H213010 at
http://www.ibm.com/support/entry/myportal/docdisplay?lndocid=migr-
5096047.
To replace an adapter, complete the following steps:
Procedure
1.
Read the safety information that begins on “Safety” on page vii and
“Installation guidelines” on page 283.
2. Turn off the server and peripheral devices and disconnect the power cords
and all external cables.
3. Remove the server top cover (see “Removing the top cover” on page 146).
4. Determine which expansion slot you will use for the adapter. If you are
installing an adapter in PCI expansion slot 1, 2, or 3, remove riser-card
assembly 1; if you are installing an adapter in expansion slot 6, 7, or 8,
remove riser-card assembly 2. See Removing a riser-card assembly
5.
▌1▐
Slide the retention bracket; then,
▌2▐
rotate it to the open position.
6. Slide the expansion-slot cover out of the riser-card assembly expansion slot.
7. Align the adapter with the PCI connector on the riser card and press the
adapter firmly into the PCI connector on the riser card.
192
System x3650 M5 Type 5462: Installation and Service Guide