IBM System x3650 M5, Инструкция по установке и обслуживанию, Страница: 205 / 1010

Removing an adapter in the rear two hard-disk-drive kit:
Use this information to remove an adapter in the rear two hard-disk-drive kit.
About this task
To remove an adapter in the rear two hard-disk-drive kit, complete the following
steps:
Procedure
1. Read the safety information that begins on “Safety” on page vii and
“Installation guidelines” on page 283.
2. Turn off the server and peripheral devices and disconnect all power cords;
then, remove the top cover (see “Removing the top cover” on page 146).
3. Press down on the left and right side latches and slide the server out of the
rack enclosure until both slide rails lock; then, remove the top cover (see
“Removing the top cover” on page 146).
4. Remove the rear two hard-disk-drive kit that contains the adapter (see
“Removing the rear two hard-disk-drive kit” on page 200).
v
If you are removing an adapter from PCI expansion slot 3, remove rear two
hard-disk-drive kit 1.
v
If you are removing an adapter from PCI expansion slot 8, remove rear two
hard-disk-drive kit 2.
5. Disconnect any cables from the adapter (make note of the cable routing, in case
you reinstall the adapter later).
6.
▌1▐
Slide the retention bracket; then,
▌2▐
rotate it to the open position.
7. Remove the screws if present. These screws can be fastened to the side of the
riser-card assembly for storage if needed.
8.
▌3▐
Carefully grasp the adapter by its top edge or upper corners, and pull the
adapter out of the rear two hard-disk-drive kit.
9. If you are instructed to return the adapter, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
1
3
2
Adapter
Adapter connector
Bracket
Rear two hard-disk-drive kit
Figure 118. Adapter removal
Chapter 5. Removing and replacing components
189