IBM System x3650 M5, Инструкция по установке и обслуживанию, Страница: 248 / 1010

Removing the 2.5-inch simple-swap backplate
assembly/hot-swap hard disk drive backplane
Use this information to remove the 2.5-inch simple-swap backplate
assembly/hot-swap hard disk drive backplane.
About this task
To remove the 2.5-inch simple-swap backplate assembly/hot-swap hard disk drive
backplane, complete the following steps:
Procedure
1. Read the safety information that begins on “Safety” on page vii and
“Installation guidelines” on page 283.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables, if necessary.
3. Remove the top cover (see “Removing the top cover” on page 146).
4. Pull the hard disk drives or fillers out of the server slightly to disengage them
from the backplate assembly/backplane. See “Removing a hot-swap hard disk
drive” on page 154and “Removing a simple-swap hard disk drive” on page 157
for details.
5. To obtain more working room, remove the fan cage assembly (see “Removing
the fan cage assembly” on page 172).
6. Lift the two front release latches and rotate the backplate assembly/backplane
toward the rear of the server to remove the backplate assembly/backplane.
Figure 180. Attaching the redundant power information label
232
System x3650 M5 Type 5462: Installation and Service Guide