IBM Netfinity 3000, Руководство пользователя, Страница: 71 / 370

The Configuration/Setup Utility program
Note: Depending on the configuration changes that occurred, the
error message that you see might be different from the one
shown here.
If the preceding screen appears, select Continue until you reach the
Configuration/Setup Utility program menu; then, go to “Using the
Configuration/Setup Utility program” on page 39.
If the preceding screen does not appear, use the following
procedures to access the Configuration/Setup Utility program
menu.
To start the Configuration/Setup Utility program:
1. Turn on the server and watch the screen.
If your server is already turned on, turn off the server, wait a
few seconds until all in-use lights go off, and then turn the
server back on. (Do not use Ctrl+Alt+Del to restart the server.)
2. When the message
Press F1 to enter Configuration/Setup
appears, press F1. The Configuration/Setup Utility program
menu appears. For information about the menus, see “Using
the Configuration/Setup Utility program” on page 39.
POST Startup Error(s)
The following error(s) were detected when the system was
started:
162 Configuration Change Has Occurred
Select one of the following:
Continue
Exit Setup
Chapter 3. Configuring your server
37