IBM Netfinity 3000, Руководство пользователя

Страница: 292 / 370

Setting the microprocessor speed switches
When you replace a microprocessor with one that has a different
speed
13 , you must change the switch settings on the system board.
Before you begin:
Ÿ
Read “Electrical safety” on page 70 and “Handling
static-sensitive devices” on page 71.
Ÿ
Turn off the server and all other connected devices.
Ÿ
Disconnect all external cables attached to the server; then,
remove the server cover (see “Preparing to add options” on
page 73).
Ÿ
Locate the Flash BIOS in “Remote Administration” on page 52.
Note: If you have not already done so, go to
http://www.ibm.com/pc/support/ on the World Wide Web
and download the appropriate flash update program.
Review the applicable README files, and use this
information to create a Flash BIOS Diskette. Perform the
POST/BIOS (flash) update procedure (see “Remote
Administration” on page 52 for additional information).
1. Locate the configuration switches (also known as rocker
switches) on the system board. For more information, refer to
the label inside the server, or see “System Board Illustration” on
page 253.
2. To set the appropriate microprocessor speed, set switches 1 to 4
as shown in the following tables. It might be helpful to use the
end of a small screwdriver to set the switch.
Note: Switches 5 to 8 are not used for microprocessor speed
settings.
13 MHz denotes internal clock speed of the microprocessor only; other factors also affect application performance.
258
Netfinity 3000 User's Handbook