IBM Netfinity 3000, Руководство пользователя

Страница: 225 / 370

POST Messages
POST message Description
1962 A startup sequence error occurred.
Action:
1. Make sure that the startup options are set correctly in the
Configuration/Setup Utility program. If the settings are not
correct, change and save them. For instructions on using the
Configuration/Setup Utility program, see “Using the
Configuration/Setup Utility program” on page 39.
2. Make sure that the primary IDE or SCSI cable is properly
installed and securely connected.
3. Make sure that all adapters are installed correctly. For
instructions on adding adapters, see “Installing or removing
ISA and PCI adapters” on page 82.
If the problem cannot be isolated and corrected, have the system
serviced.
2462 A video configuration error occurred.
Action:
1. Make sure that the primary monitor signal cable is securely
attached to the monitor and the monitor connector (video
port) on the rear of your server. To find the location of the
video port, see “Input/output connectors” on page 11.
2. Make sure that the graphics adapter in your server, if you
installed one, is securely connected to the connector where
you installed it (an ISA or PCI slot connector on the riser
card, or the dedicated AGP slot connector in the server wall).
For the location of the ISA and PCI slot connectors on the
riser card, see “ISA and PCI adapters” on page 80. For the
location of the dedicated AGP slot connector, see “System
Board Illustration” on page 253.
3. If you just added or removed video memory, you must save
the new configuration in the Configuration/Setup Utility
program. See “Using the Configuration/Setup Utility
program” on page 39 for additional information and
instructions on saving the configuration.
If the problem cannot be isolated and corrected, have the system
serviced.
Chapter 5. Solving problems
191